SAFETY INFORMATION In order to ensure a safety use of the generator please follow the next safety instructions: 1. Check the outside of the generator in order to detect any apparent trouble. 2. Check the screws and nuts, they could loosen because of the equipment vibration.
Technical data Open Components General view Side view Control panel LED 5 First startup Preparation before starting up Starting the Generator Stopping the generator Engine maintenance First oil change after 20 hours Oil filter Air filter Diesel filter General maintenance Prolonged storage Troubleshooting...
Technical data Open Product Size (mm) Packaging Size (mm) Package Model Material Lenght Width Height Lenght Width Height Carton Carton Carton Carton Frequency (Hz) Rated Power Max.Power Voltage (V) DC Output Fuel Tank Capacity (L) Noise Level (dBA) Direct injection Direct injection Direct injection Direct injection...
Page 5
COMPONENTS General view 1 Fuel tank 2 Control Panel 3 Oil filter 4 Oil drain screw 5 Injection pump 6 Recoil starter 7 Oil refill / Oil dipstick Side view 1 32 mm Frame 2 Muffler 3 Oil cap 4 Battery 12V 36Ah 5 Starter Control panel LED 5 1 ON/OFF key contactor...
Page 6
First startup IT IS NECESSARY TO PURGE THE FUEL CIRCUIT 3.1. Preparation before starting up Put oil on the motor (Fig.1) using 15W40 oil, 1.6Lt maximum, check the level with the dipstick without screwing it in, the level must remain the the maximum line (without exceeding the upper mark).
Page 7
First startup Stopping the generator Turn the differential to the "OFF" position (down, Fig 9) and disconnect the equipment connected to the control panel. (If you miss this step, you may damage the voltage regulator AVR). To stop the engine, turn the key or turn the switch (depends on version) to "OFF"...
Page 8
Engine maintenance First oil change after 20 hours Place a recipient underneath to catch the oil. Loosen the drain screw. Drain the engine oil. Fit and tighten the drain screw again. Replace the gasket screw at each change to avoid losses. Fill the engine with new oil 15W40 (1.6Lt).
General maintenance Never encline the generator during transportation without emptying the oil pan. Failure to observe this instruction may cause severe damage to the engine . We recommend cleaning the equipment after use and before a storage. Visually check the external components. Check the screws and nuts due to equipment vibration could loosen.
TROUBLESHOOTING Insufficient fuel Fill in the fuel Air in fuel circuit Purge air in fuel circuit No spray on injector or a little quantity Repair and adjust the injector No start of the Speed control rod not at “RUN” position Set control rod to “RUN”...
Page 11
Technical data Open Components Front view Outside view Control panel LED 5 First startup Preparation before starting up Starting the Generator Stopping the generator Engine maintenance First oil change after 20 hours Oil filter Air filter Diesel filter General maintenance Prolonged storage Troubleshooting...
Page 12
Technical data Silent Product Size (mm) Packaging Size (mm) Package Model Material DHY6000SE DHY6000SE-3 DHY8000SE DHY8000SE-3 Frequency (Hz) Rated Power 6,6 Kva Max.Power Voltage (V) DC Output 12 l 12 l 12 l 12 l Fuel Tank Capacity (L) Noise Level (dBA) Direct injection Direct injection Direct injection...
Page 13
General view 1 Fuel filter 2 Battery 12V 36Ah 3 Oil filter 4 Transport wheels 5 Injection pump 6 Starter lever 7 Oil refill / Oil dipstick Side view Diesel tank 2 Lifting point 3 Back exhaust 4 Control panel 5 Engine access 6 Carrying handle 7 Air filter...
Page 14
First startup 3.1. Preparation before starting up Put oil on the motor (Fig.1) using 15W40 oil, 1.6Lt maximum, check the level with the dipstick without screwing it in, the level must remain the the maximum line (without exceeding the upper mark). Fill the fuel tank with diesel (Fig 2), with 17 liters (depending on the version).
Page 15
Engine maintenance First oil change after 20 hours Place a recipient underneath to catch the oil. Loosen the drain screw. Drain the engine oil. Fit and tighten the drain screw again. Replace the gasket screw at each change to avoid losses. Fill the engine with new oil 15W40 (1.6Lt).
Page 16
General maintenance Never encline the generator during transportation without emptying the oil pan. Failure to observe this instruction may cause severe damage to the engine . We recommend cleaning the equipment after use and before a storage. Visually check the external components. Check the screws and nuts due to equipment vibration could loosen.
Page 17
TROUBLESHOOTING Insufficient fuel Fill in the fuel Air in fuel circuit Purge air in fuel circuit No spray on injector or a little quantity Repair and adjust the injector No start of the Speed control rod not at “RUN” position Set control rod to “RUN”...