IVT CSD Li-14.4G-RC Instruction Manual page 10

Instruction manual
STEPLESS SPEED CONTROL
The machine runs with variable speed
between 0 and maximum depending on the
EN
pressure applied to the On / Off switch (3).
CHANGING
DIRECTION [F6]
WARNING! Operate the rotational
direction switch (2) only at a standstill.
With the rotational direction switch (2), the rotational
direction of the tool can be changed (when the On / Off
switch (3) is operated, the rotational direction switch (2)
is locked).
Right Rotation (forward)
Press the rotational direction switch (2) through to the
right stop (for drilling, driving screws, etc.).
Left Rotation (reverse)
Press the rotational direction switch (2) through to the
left stop (for loosening and unscrewing screws and
nuts).
SELECTOR SPEED (6) [F7]
With the speed selector speed (6), you can change over
from first to second gear and you can work at higher or
lower speed.
To avoid damages, you should only change over gears
when the tool has stopped.
LED LAMP (9)
The LED lamp (9) can be used in poor lighting conditions
to illuminate the area where you want to drill or screw.
The LED lamp (9) will be lit automatically as soon as you
press the On/Off switch (3).
MAINTENANCE AND STORAGE
CAUTION! Before any work on the
device itself, pull off the battery.
∙
Always keep the tool and the ventilation slots (if
present) cleaned. Regular cleaning and maintenance of
the appliance will ensure efficiency and prolong the life
of your tool.
THE ROTATIONAL
∙
If the tool should fail despite the rigorous
manufacturing and testing procedures, the repair should
be carried out by an authorized IVT customer service.
∙ Keep all nuts, bolts, and screws tight, to be sure the
tool is in safe working condition.
∙
Replace worn or damaged parts for safety.
∙ Use only original spare parts. Parts not produced
by manufacturer may cause poor fit and possible injury.
∙ Store the tool in a dry room out of reach of kids and
away from any flammable material.
∙
Never wet the device or spray water on it!
ENVIRONMENTAL PROTECTION
Recycle raw materials instead of
disposing as waste.
Tool, accessories and packaging should be sorted for
environment-friendly recycling.
The plastic components are labeled for categorized
recycling. These instructions are printed on recycled
paper manufactured without chlorine.
10