WARNING
Installation, first ignition and maintenance work
must be performed by qualified personnel only, in
accordance with the instructions provided.
Incorrect installation may harm individuals, animals or
property; the manufacturer will not be held responsible
for any damage caused as a result.
If the appliance is installed inside the apartment,
make sure that all provisions relating to the air
inlet and room ventilation (in compliance with
current legislation) are respected.
Control pannel
1
1 - Knob for gas regulation
2 - Red L.E.D. - battery power level
3 -
D.H.W flow/temperature knob
Battery insertion
- unhook the battery compartment cover placed on
the bottom of the appliance
- Insert 2 batteries (1,5V LR20) in the appropriate
compartment while observing the polarities indicated
on the device.
Battery replacement
- unhook the battery compartment cover placed on the
bottom of the appliance
- remove the battery and replace observing the polarities
indicated on the device.
ATTENTION!!
Used batteries can not be dispersed
environment. Used batteries can not be utilized.
2
3
in the
Ignition procedure
- ensure that the cock located on the cold water fitting is
open
- ensure that the gas cock is open
- make sure the batteries provided (1.5V LR20) were
correctly inserted.
- Turn the knobs between the positions of minimum and
maximum.
The device is ready to operate
By opening a tap, the device automatically starts
operating.
Note: If the device does not operate, ensure that the gas
and/or cold water cocks are open.
Ensure that the device is electrically powered.
Make sure the batteries were inserted.
When closing the tap, the device automatically switches
off.
WARNING!!
Water with a temperature higher than 50°
cause serious burns.
Always verify water temperature before
use.
WARNING!!
The casing can reach high temperatures in
the area of the burner.
USER'S MANUAL
/
5