Extreme Networks ExtremeWireless AP460C Installation Manual page 22

Install the Access Point on a Flat Surface
4. Torque the M5 shoulder mounting screws to 25 in-lbs.
5. Remove the two locking screws on the accessory.
Figure 8: ASM accessory locking screws
6. Insert the M5 bolt heads on the access point into the large end of the accessory keyholes and slide
the access point down until the bolts rest in the narrow end of the keyholes.
7. Tighten the locking screws on the ASM accessory to secure the access point.
8. Ground the access point.
22 ExtremeWireless™ AP460C, AP460S6C, and AP460S12C Access Points
Note
The access point will not go onto the accessory if the locking screws are not removed.
Install the Access Point