Infotainment Amundsen; Infotainment Overview; System - Skoda Scala 2020 Owner's Manual

Infotainment Amundsen

Infotainment overview

Touchscreen
A
All menus
Favourite menus
Increase volume
Reduce volume
Depending on the status:
Infotainment switched off
▶
▶ Tap: Turn on Infotainment
Infotainment switched on
▶
Tap: Switch sound off/on
▶
▶ Hold: Switch off Infotainment
Radio menu
Media menu
Phone menu
Navigation menu
Information about vehicle settings

System

Limitation
For safety reasons, operation of some Infotainment
functions while driving is not possible or is restricted.
The Infotainment system indicates this by means of
a message in the screen.
Basic settings
Setting basic functions
The following Infotainment functions are set in the
menu:
Time and date
▶
Language
▶
Units
▶
Infotainment Amundsen ›
Restore factory settings
▶
Sound settings
The Infotainment sound is set in the menu
The following menu items can be set:
Setting the equalizer
▶
Adjusting the volume ratio
▶
Volume adjustment of individual Infotainment
▶
functions
The volume can be adjusted on e.g. one of the fol-
lowing menu items:
▶ Volume adjustment of voice commands
▶ Setting the maximum volume when Infotainment
is turned on
▶ Speed-dependent volume setting
Setting the Infotainment to mute with the park-
▶
ing aid switched on
Depending on the equipment, the following ad-
vanced sound settings can be set
Setting space optimisation
▶
Setting the audio profiles according to genre
▶
Adjusting the subwoofer volume
▶
Configuration wizard
The configuration wizard helps to set certain Info-
tainment functions.
The configuration assistant is automatically displayed
if the ignition is switched on and if there are at least
two menu items that have not been set up after
switching on the Infotainment.
›
To switch off the automatic display, when the
configuration assistant is displayed tap Don't show
again .
›
For manual display tap
Set up menu HOME
›
To display another page of the HOME menu, press
the screen with two fingers and drag it to the left
or right.
To add the preferred menu, proceed as follows:
›
Tap on an empty functional surface.
Or:
›
Press and hold an occupied functional surface and
then tap on an empty functional area.
›
Select a menu with the desired dimension of the
functional surface.
›
Tap on to exit edit mode.
To remove the preferred menu, proceed as follows:
›
Press an occupied functional surface.
›
Tap on .
›
Tap on to exit edit mode.
Infotainment overview 91
.
Configuration wizard .