Brinkmann PROFESSIONAL STAINLESS STEEL Charcoal Grill Owner's Manual page 14

INS_810-3214-S_ProGrill.qxd
Grilling/Searing
Charcoal grate
Middle Low/Middle High Charcoal Tray Level
(Grilling)
Charcoal grate
High Charcoal Tray Level
(Searing)
13
5/30/07 4:56 PM Page 14
Step 1
Lightly coat all interior surfaces of the Professional Stainless Steel
Charcoal Grill including cooking grill with vegetable oil or vegetable oil
spray. Do not coat charcoal grate or charcoal ash tray.
Step 2
Follow the instructions below carefully to build a fire. You may use
charcoal and/or wood as fuel in the Professional Stainless Steel
Charcoal Grill (see "Adding Charcoal/Wood During Cooking" section of
this manual).
WARNING: Never use charcoal that has been pre-treated with lighter
If using a Charcoal Chimney Starter, follow all manufacturer's warnings
and instructions regarding the use of their product. Start with 8 to 10
pounds of charcoal. This should be enough charcoal to cook with,
once the curing process has been completed. When charcoal is
burning strong, carefully place hot coals in center of charcoal grate.
WARNING: DO NOT use grill without charcoal ash tray in place. DO NOT
NOTE:
If you choose to use charcoal lighting fluid, ONLY use charcoal lighting
fluid approved for lighting charcoal. Do not use gasoline, kerosene,
alcohol or other flammable material for lighting charcoal. Follow all
manufacturer's warnings and instructions regarding the use of their
product. Start with 8 to 10 pounds of charcoal . This should be enough
charcoal to cook with, once the curing process has been completed.
Place the charcoal in center of charcoal grate.
Step 3
Saturate charcoal with lighting fluid. With lid open wait 2 to 3 minutes
to allow lighting fluid to soak into charcoal. Store charcoal lighting fluid
safely away from the grill.
Step 4
With grill lid open, stand back and carefully light charcoal and allow to
burn until covered with a light ash (approximately 20 minutes).
WARNING: Charcoal lighting fluid must be allowed to completely burn off
fluid. Use only a high grade plain charcoal or charcoal/wood
mixture.
attempt to remove charcoal ash tray while tray contains hot
coals.
To extend the life of your grill, make sure that hot coals and
wood do not touch the walls of grill.
IF USING CHARCOAL CHIMNEY STARTER, PROCEED TO STEP 5
prior to closing grill lid (approximately 20 minutes). Failure to
do this could trap fumes from charcoal lighting fluid in grill
and may result in a flash-fire or explosion when lid is opened.