Health O Meter 500HB Installation Instructions Manual page 4

5. Tilt the front edge of the Base toward
the top of the Scale opening a gap at
the rear of the Scale. Caution: Ensure
the load cell cable does not
disconnect from the load cell port.
6. Through the opening in the gap, slide
the Spacer into the Gap. Position the
Spacer so that the open end of the
Spacer slides around the Load Cell
Cable.
7.
Slide Spacer into Base and position
Spacer so that Mount Holes in Spacer
align with Holes in Base.
8.
Insert the two Screws removed in step 3
into the Mount Holes on bottom of
Base.Then tighten all 4 Screws securely.
Note: If assembling a new scale, refer
back to the scale's user manual to
complete the scale assembly before
proceeding with mounting the
handlebars.
P/N 82-00009 REV A 500HB Installation Instructions REV20200402_web
Gap at Rear of Gap at Rear of
Base
4
Base