Royal 56 S-MS Assembly And Operating Instructions Manual page 28

Anleitung_RPM_56_S_MS_SPK7__ 08.05.12 16:34 Seite 28
GB
8. Disposal and recycling
The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.
9. Faults and remedies for faults
Caution: Always switch off the engine and pull the ignition cable before starting any inspection or adjustment
work.
Caution: If, after making an adjustment or repair to the engine, you let it run for a few minutes, remember that
the exhaust and other parts will get hot. Thus, do not touch parts that emanate heat, as these may burn you.
Fault
Loud while running, machine
vibrates heavily
Engine does not start
Engine runs unsteadily
Uneven mowing results
Unsatisfactory bagging of the
grass
28
Possible cause
- Screws are loose
- Blade fasteners are loose
- Blade is unbalanced
- Brake lever not pressed
- Speed lever in wrong position
- Spark plug is defective
- Fuel tank is empty
- Air filter is soiled
- Spark plug is soiled
- Blade is blunt
- Cutting height is too low
- Engine speed is too low
- Engine speed is too low
- Cutting height is too low
- Blade is worn
- Basket is clogged
Remedy
- Check screws
- Check blade fasteners
- Replace blade
- Press brake lever
- Check setting
- Replace spark plug
- Refill with fuel
- Clean the air filter
- Clean the spark plug
- Sharpen the blade
- Set correct height
- Set lever to max.
- Set speed lever to max.
- Set correct height
- Replace the blade
- Empty the basket