1.2.2
Installing a Probe Holder
To install a probe holder on the bar
1.
On top of the holder, unscrew the wing screw enough to loosen the bar socket (see
Figure 1-3 on page 13).
2.
Move the probe holder on the bar to the desired position and screw the wing
screw tight enough to hold the probe holder in place.
1.2.3
Installing an Encoder
The Mini-Wheel encoder (see Figure 1-4 on page 14) can be installed two different
ways according to the scanning direction needed.
Wing screw
Figure 1-3 Loosening the bar socket
Setting Up and Operating the HST-X04 Scanner
DMTA020-01EN, Rev. C, March 2014
13