Figure 1-6 The Mini-Wheel Encoder Installed On The Inside Of The Encoder Holder; Figure 1-7 The Two Encoder Holder Screws - Olympus HST-X04 User Manual

Weld
Scan direction

Figure 1-6 The Mini-Wheel encoder installed on the inside of the encoder holder

To install the encoder
1. Use the hexagonal key to loosen the screw securing the Mini-Wheel encoder pin
into the encoder holder (see Figure 1-7 on page 15).
Weld
Scan direction

Figure 1-7 The two encoder holder screws

Setting Up and Operating the HST-X04 Scanner
DMTA020-01EN, Rev. C, March 2014
Loosen encoder-
holder screw on
the probe holder.
15