Installing A Probe Holder; Installing An Encoder; Figure 1-3 Loosening The Bar Socket - Olympus HST-X04 User Manual

1.2.2

Installing a Probe Holder

To install a probe holder
1. On top of the holder, unscrew the wing screw enough to loosen the bar socket (see
Figure 1-3 on page 13).
2. Move the probe holder on the bar to the desired position and screw the wing
screw tight enough to hold the probe holder in place.
1.2.3

Installing an Encoder

The Mini-Wheel encoder (see Figure 1-4 on page 14) can be installed two different
ways according to the scanning direction needed.
Wing screw

Figure 1-3 Loosening the bar socket

Setting Up and Operating the HST-X04 Scanner
DMTA020-01EN, Rev. D, September 2016
13