AT&T Definity 8434 User Manual page 8

Communications system and voice terminal
Hide thumbs Also See for Definity 8434:
Table of Contents

Advertisement

Drop button
Test button
Conference button
Shift button
Transfer button
Volume control
button
10 Call appearances/
feature buttons
For disconnecting from a call or dropping the last party
added to a conference call.
When the voice terminal is initially powered up, the
green light next to [
PBX is not (or not yet) operational. The light changes to
steady green when the voice terminal is able to
communicate with the PBX, and then goes off after a
short period of time. After the voice terminal is powered
up, you can press [
display on your voice terminal.
For setting up conference calls. This button is labeled
[
] .
Conf
A blue button which can be used to access two additional
features (when [
button is on):
When used with [
personalized ring from among eight available
patterns.
When used with [
acoustic test of the environment and adjust the
speakerphone to the surrounding acoustic
environment for optimal performance (for the
built-in speakerphone option only).
For transferring a call to another voice terminal.
For adjusting the volume of the following:
The speakerphone or speaker when a call is in
progress using the 2-way speakerphone or 1-way
speaker
The handset receiver level while a call is in progress
using the handset
The tone ringer when the speaker is off and either
the handset is inactive or the tone ringer is active
Note: When the speaker is active, the ringer volume is
automatically reduced to a low setting. The volume is
restored when the speaker is turned off.
Remember: The Volume control button on your voice
terminal does not control the volume level of adjunct
equipment.
At least three of these 10 buttons are devoted to
incoming and outgoing calls (call appearances) and
are labeled with an extension number; the remaining
buttons can also be call appearance buttons, or they can
access features (feature buttons) and are therefore
labeled with a feature name.
] flashes if the link with the
Test
] to test the lights and the
Test
] is active, the red light next to the
Shift
] , you can select a
Hold
] , you can perform an
Speaker

Advertisement

Table of Contents
loading

This manual is also suitable for:

Definity generic 1Definity generic 3Definity system 75

Table of Contents