AT&T Definity 8434 User Manual page 22

To place an AD call
To program/reprogram
an outside number,
extension, or feature
access code into a
personal list
3
Press [ ] and then press the softkey below Prog
Menu
or, if Prog is not available on your display,
press [
Program
or Dial AD Program access code
4 Press [
AD xxxxx
5 Dial outside number, extension, or feature access
code you want to store (up to 24 digits)
Note: You may also be able to use the softkeys to
add special functions such as Pause, Mark, Wait, or
Suppress into the telephone numbers programmed
on the AD button.
If you are programming an outside number, be sure
to include a trunk code, if applicable.
6
Press [ ]
#
Number is stored
•
Repeat Steps 4 through 6 to program additional
•
buttons
7 Hang up or press [
1
Press selected [
2 Call is automatically dialed
On a separate sheet of paper, write down the outside
1
numbers, extensions, and/or feature access codes you
want to program as items on your personal lists(s)
Note: Each phone number or feature access code is
stored as a separate item.
2
Pick up handset
Note: If you are using the built-in speakerphone,
you must either press a call appearance button or
press [
Speaker
Press [ ] and then press the softkey below Prog
3
Menu
or, if Prog is not available on your display,
press [
Program
or Dial AD Program access code
4 Dial Personal List number (1, 2, or 3)
]
] to be programmed
] to end programming
Drop
]
AD xxxxx
] before you begin Step 3.
]
[dial tone]
[dial tone]
[confirmation tone]
[ringback tone]
[dial tone]
[dial tone]
[dial tone]
17