Assembly; Unpack Pressure Washer; Attach Handle; Connect Hose And Water Supply - Briggs & Stratton Electric Pressure Washer Operator's Manual

Assembly

Read entire operator's manual before you attempt
to assemble or operate your new pressure washer.
Your pressure washer requires some assembly but is quickly
ready for use. If you have any problems with the assembly of
your pressure washer, please call the pressure washer
helpline at (800) 743-4115.
Tools Needed
• 4mm allen wrench (included)
• Needle nose pliers

Unpack Pressure Washer

1. Remove everything from carton except pressure
washer.
2. If pressure washer is too heavy for you to lift, open
carton completely by cutting each corner from top to
bottom.
Items in the carton include:
• Pressure washer
• Pressure washer handle
• Spray gun
• Nozzle extension with adjustable nozzle
• Nozzle extension with turbo nozzle
• Parts bag (which includes the following):
• Handle attachment allen screws (4)
• Operator's manual
• Owner's registration card
• Safety goggles
• Nozzle cleaning tool
Check all contents. If any parts are missing or damaged, call
the pressure washer helpline at (800) 743-4115.
Become familiar with each component before assembling the
pressure washer. Identify contents with the illustration
shown in Features and Controls.
To prepare your pressure washer for operation, you will
need to perform these tasks:
1. Fill out and send in registration card.
2. Attach handle to main unit.
3. Connect high pressure hose to spray gun.
4. Connect water supply to pump.
5. Attach nozzle extension to spray gun.
6

Attach Handle

1. Place handle (A) on top of pressure washer with red
handle above power cord and hole in handle aligned
with the screw holes in the back of the pressure
washer.
B
2. Using 4 supplied allen screws (B), attach handle to
pressure washer with provided 4mm allen wrench.
Tighten until screws are snug.

Connect Hose and Water Supply

1. Remove and discard shipping cap from the unit's water
inlet using a needle nose pliers.
2. Confirm water inlet screen (C) is installed.
NOTE: If inlet screen is damaged or missing, DO NOT use
pressure washer. Call (800) 743-4115 for assistance.
NOTICE
DO NOT run the pump without the water supply connected
and turned on.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
A
C
BRIGGSandSTRATTON.COM