Table of Contents
Advertisement
Cleaning and care
^ After selecting either PY I or PY 2,
start the pyrolytic cleaning process
by pressing the Q button.
The door will lock and the oven will
begin to heat up.
You can see the process of the
pyrolytic programme by selecting the
g symbol.
During the first 5 minutes after the start
you can delay the end of the pyrolytic
programme, e.g. to take advantage of
cheaper night electricity tarifs. To do
this:
^ Select the ) symbol and delay the
end using the P button.
You can change the end time at any
time up until the delay period has
elapsed.
At the end of the pyrolytic
programme
– the ) symbol will flash.
– a buzzer will sound, if this option is
selected (see "Settings %").
^ Turn the function selector to "0".
The buzzer will stop and the symbols in
the display will go out.
If you don't operate the function
selector, the buzzer will sound every 5
minutes to remind you of the finished
programme. This reminder
programme will run for up to
30 minutes.
46
After the pyrolytic process, any
debris (e.g, ash), can easily be wiped
away.
Remember to wait until the oven has
cooled down before doing so!
Danger of burning!
Try not to wipe over the fibre-glass
seal when cleaning the oven cavity.
It is particularly sensitive and should
not be cleaned unless absolutely
necessary. Rubbing it can damage
it.
Most residues are easily wiped away
with a damp cloth.
Depending on soiling levels in the oven,
there may be visible deposits on the
door and below the trim under the oven
cavity. This is best removed using a
non-abrasive sponge or non-abrasive
stainless steel spiral pad and a mild
solution of warm water and washing-up
liquid.
Deposits on the internal door panel can
be removed using a suitable glass
scraper.
Spilt fruit juices may cause lasting
discolouration to the surfaces. This
discolouration is permanent but will
not affect the efficiency of the
enamel. Do not attempt to remove
these marks.
Advertisement
Table of Contents
