4.4
RTD Interface
The SP-005 supports 100, 500, and 1000 ohm Platinum RTD sensors in 2, 3, and 4-wire configurations. To use these
features, follow these steps:
Note:
A single RTD connection is supported.
Step 1:
Click the Inputs Configuration Tab on SYNC and choose your input type from the Type dropdown.
Step 2:
Click the input you wish to configure and select your RTD type from the Device Range/Type dropdown.
Step 3:
Click the Wire dropdown and choose your wiring configuration.
4.5
Setting Alarms
Alarms are set by clicking the
the threshold and alarm type in the Condition section and then select which output to turn on in the Action section. The
alarm can be set to be latching or non-latching in the Recovery section.
icon in SYNC on the desired input signal found in the Inputs Configuration Tab. Setup
11 |
P a g e