Troubleshooting - Dometic CAM1000 Installation And Operating Manual

CAM 1000 / BSC 01
The test indicator allows the camera to be correctly aligned with the front of the vehicle. The
reference line (fig. a 1) shall be at least in alignment with the front of the vehicle. The active area
(fig. a 2) is marked as a red area in the video for 6 seconds.
I
NOTE
In night mode with ambient lighting below 50 lux, the camera switches to black and
white mode. This is necessary to optimize object detection even in poor lighting con-
ditions.
The CAM1000 / BSC01 is automatically activated at a speed of less than 40 km/h.
As soon as objects move in the same direction and faster as the vehicle, the dynamic arrow indica-
tor (fig. b 3) appears in the display. If the audible signal is connected, an evenly repeating beep
will sound.
9

Troubleshooting

Fault
The device shows no
function.
"NO SIGNAL" is
displayed on the
monitor.
A yellow GPS icon
appears on the monitor.
A red GPS icon appears
on the monitor.
Frequent wrong indica-
tion at the end of the
vehicle when driving
right in a curve.
EN
Cause
The system plug is not con-
nected or not correctly plugged
into the control electronics.
No video signal present. Loose
contact in the plug connector of
the camera cable
The camera is defective.
GPS reception is faulty.
No object detection is available.
The camera points too far back.
Due to the 180° angle of view of
the camera, the image moves
from back to front and the system
also detects non-relevant
objects.
Troubleshooting
Solution
Check the system plug and make
sure that it locks into place.
Check that the connections are
secure.
Contact an authorized service
center to replace the camera.
The system is active but the
acoustic warning signal is off until
a better GPS reception is
obtained.
Check that the connections are
secure.
Align the camera as perpendicu-
lar as possible. The red test field
should stop at about 8 m from
the front of the vehicle.
11