Connecting The Cam1000 / Bsc01 - Dometic CAM1000 Installation And Operating Manual

CAM 1000 / BSC 01
6.1 Instructions before installation (change acceptance)
• The system BVS71000 - CAM1000/ BSC01 + M75LXAHD with ABE-Nr. KBA91843 requires a
change acceptance by a testing laboratory (for example, DEKRA, TÜV, only for Germany and
Austria).
• Please observe the manufacturer's installation guidelines.
• The load status has no effect on the function of the system as long as the installation instructions
are observed.
• The electrical connection and commissioning may only be carried out by a specialist in accord-
ance with the information in this assembly and operating manual.
• The device may only be put into operation if the user is aware of the risks and dangers resulting
from the use of the device.
Supplement to fig. 2 to fig. 8
Note the following during installation:
Setting of operation mode
• Note the detection range dependent on the position of the camera:
– Operating mode A (red letter "A" on screen) for camera positions with a mounting height
from 2 m to 3 m (fig. 2 to fig. 3):
Visible area: 37 m x 6 m, 165° FOV (field of view)
Active area: 8 m x 4 m
Closed pin bridge in setting screw
– Operating mode B (red letter "B" on screen) for camera positions with a mounting height
from 3 m to 4 m (fig. 7 to fig. 5):
Visible area: 19 m x 8 m, 140° FOV (field of view)
Active area: 8 m x 4 m
Open pin bridge in setting screw
• Use the extension rubber base in case the view to the detection zone is blocked (fig. 8).
Supplement to fig. 0
• The system only fulfills the conditions if the monitor is mounted in the area of the right A-pillar
(min. 30° to the viewing axis straight ahead). Use the extension rubber base in case the view to
the detection zone is blocked.
7

Connecting the CAM1000 / BSC01

Observe the following:
• As far as possible, use original ducts for laying the cables, or other suitable options such as pan-
eling edges, ventilation grilles or dummy plugs. If no openings are available, you must drill
holes for the respective cables. Check beforehand that there is sufficient space on the other
side for the drill head to emerge.
• Wherever possible, lay cables inside the vehicle, as they are better protected there than out-
side.
EN
Connecting the CAM1000 / BSC01
9