Intel P31 User Manual page 18

Fastener Cap not
resting against spring
Press Down
(4 Places)
NOTE: Thermal Solutions that come with IntelR boxed
processor use pre-applied thermal interface material
Apply Thermal
and not grease.
Interface Material
3.
4.
•
•
Fastener flush
against MB
Both fastener
halves are flush
against spring
Fastener flush
against spring
Remove Heat Sink (HS) from packaging media
Place HS onto the LGA775 Socket
Ensure fan cables are oriented on side closest to
fan header
Align Fasteners with MB through-holes
5. Inspection
•
Ensure cables are not trapped or interfere fastener
operation
•
Ensure fastener slots are pointing straight out from
heatsink
6. Actuate fasteners
•
While holding HS to prevent tilting, press down on
fastener caps with thumb to install and lock
Repeat with remaining fasteners
7. Inspection
•
Verify the fasteners are properly seated
•
Ensure both fastener cap and base are flush with
spring and motherboard
8. Connect fan header with Board header
9. Secure excess cable with tie-wrap to ensure cable
does not interfere with fan operation or contact
other components.
14