Table of Contents
Advertisement
Check code
5201
(F5)
Abnormal points and detection methods
When the detected pressure in the high pressure sensor is 1kgf/F or
less during operation, the compressor stops operation and enters into
an anti-restart mode for 3 minutes.
When the detected pressure is 1kgf/F or less immediately before
restarting, the compressor falls into an abnormal stop with check code
<5201>.
For 3 minutes after compressor restarting, during defrosting operation,
and for 3 minutes after returning from defrosting operation, above
mentioned symptoms are not determined as abnormal.
●Diagnosis of defects
Make sure to turn the power OFF before connecting/disconnecting
any connectors, or replacing boards.
Check the wiring and connector connection.
Is there any abnormality such
as disconnection, looseness or
breakage?
Check an internal pressure of the
refrigerant circuit.
Is the detected internal pressure
normal?
Check the detected pressure in 63HS,
then compare it with the internal pressure.
Is the detected pressure normal?
OCH760
High pressure sensor (63HS) trouble
Diagnosis
No
Yes
Yes
Causes and checkpoints
Defective high pressure sensor
Decrease of internal pressure caused by gas
leakage
Disconnection or contact failure of connector
Malfunction of input circuit on outdoor multi controller
circuit board
The black square (■) indicates a switch position.
63HS: High pressure sensor
Connect the wiring/connector properly.
Yes
Replace it in the case of breakage.
Check the refrigerant circuit, and recharge
No
refrigerant after repairing the leakage.
The detected pressure in 63HS can be displayed by an
operation of SW1 on the outdoor multi controller circuit board.
SW1 Setting
Display on LED1, 2
ON
−99.9–999.9
OFF
1 2
3
4
5 6 7 8
No
Replace the outdoor multi controller circuit
board.
71
Remedy
Unit
kgf/F
Replace the 63HS.
Hide quick links:
Advertisement
Table of Contents
