Technical Features And Environmental Conditions; Guidelines And Standards - Siemens Simotics T-1FW6 Configuration Manual

Description of the motor

2.3 Technical features and environmental conditions

2.3 Technical features and environmental conditions
2.3.1

Guidelines and standards

Standards that are complied with
The motors of the type series SIMOTICS S, SIMOTICS M, SIMOTICS L, SIMOTICS T,
SIMOTICS A, called "SIMOTICS motor series" below, fulfill the requirements of the following
directives and standards:
• EN 60034-1 – Rotating electrical machines – Dimensioning and operating behavior
• EN 60204-1 – Safety of machinery – Electrical equipment of machines; general
requirements
Where applicable, the SIMOTICS motor series are in conformance with the following parts of
EN 60034:
Feature
Degree of protection
Cooling
Type of construction
Connection designations
Noise levels
Temperature monitoring
Vibration severity grades
Standard component, e.g. cannot be applied to built-in motors
1)
Relevant directives
The following directives are relevant for SIMOTICS motors.
European Low-Voltage Directive
SIMOTICS motors comply with the Low-Voltage Directive 2014/35/EU.
European Machinery Directive
SIMOTICS motors do not fall within the scope covered by the Machinery Directive.
However, the use of the products in a typical machine application has been fully assessed
for compliance with the main regulations in this directive concerning health and safety.
European EMC Directive
SIMOTICS motors do not fall within the scope covered by the EMC Directive. The products
are not considered as devices in the sense of the directive. Installed and operated with a
converter, the motor - together with the Power Drive System - must comply with the
requirements laid down in the applicable EMC Directive.
28
1)
1)
1)
Standard
EN 60034-5
EN 60034-6
EN 60034-7
EN 60034-8
EN 60034-9
EN 60034-11
EN 60034-14
1FW6 external rotor built-in torque motors
Configuration Manual, 12/2020, A5E50516483B AA