Installation; Mechanical Connections; Installing The Software On Pc Hard Disk - Nokia NSW-5 Series Service Manual

NSW-5
Service Software Instructions

Installation

Mechanical Connections

Caution: Make sure that you have switched off the PC and the printer
Caution: Do not connect the PKD–1 key to the serial port. You may
The software controls the phone via a separate adapter connected to the
serial port of the PC, and to the telephone's M2BUS (DAU–9S).
Attach the dongle PKD–1 to the parallel port 1 (25–pin female D–connec-
tor) of the PC. When connecting PKD–1 to the parallel port, be sure that
you insert the computer side of the PKD–1 to the PC (male side). If you
use a printer on parallel port 1, install the PKD–1 between the PC and
your printer cable.
The PKD–1 should not affect devices working with it. If some errors occur
(errors in printing are possible) please try printing without the PKD–1. If
printing is OK without the PKD–1 please contact your dealer. We will offer
you a new PKD–1 in exchange for your old one.

Installing the Software on PC Hard Disk

The program is delivered on a diskette and is copy protected with a
dongle PKD–1. It must be present in parallel port when using Service
software.
The program can also be installed on the hard disk, which is recom-
mended to obtain a maximal data access rate.
Keep the original diskette safe to enable upgrading of the program !
If you plan to use PCL Start service software, you must install it before
installing Service software, see the PCL Start installation instructions.
To install the new Service software program, follow the steps below:
1.
2.
3.
Page 8
before making connections.
damage your PKD–1 !
insert the new Service software diskette
into drive A: of your computer
start Windows, and open File Manager
log into drive a:
start INSTALL.EXE and
install Service software to drive C:
E Nokia Mobile Phones Ltd.
PAMS Technical Documentation
type A: and press <Enter>
type C: and press <Enter>
Issue 1 10/00