Custom Dialog Boxes; Buttons - Nokia NSW-5 Series Service Manual

PAMS Technical Documentation

Custom Dialog boxes

All custom dialog boxes contain the predefined buttons as defined below
in the section – Buttons. However, it is recognised that features may re-
quire additional button types, but the addition of these non–standard but-
tons should be carefully considered to minimise any inconsistencies be-
tween implementations.
The buttons are positioned down the right–hand side of the dialog boxes.
The default action is OK, except where that default action could result in
an irretrievable failure.
All tuning dialogs that contain tuning results, display the old tuned data
read from the phone before the tuning was performed, as well as the
newly tuned data.
List boxes are used to display lists of data, such as tuning data, test re-
sults etc.

Buttons

All buttons are Microsoft style buttons.
In general, the default button is the action button, the Close button or the
Yes button, but this depends on the context of the dialog box that the but-
ton is associated with.
(action) button:
Close button:
Cancel button (Esc):
Yes button (ALT+Y or Y):
No button (ALT+N or N):
Help button (ALT+H):
Issue 1 10/00
Accepts and validates entered settings and values and closes
the dialog. If the values have not been changed, then no action
will be taken. The status bar will reflect the status. The user
should only be queried, if the settings or values accepted will
over–write data that CAN NOT be reproduced.
A greyed OK button indicates that settings selected by the user
are not acceptable.
Closes the current dialog box. Does not send or store anything
and closes the dialog. The Close button is only used for dia-
logs that do not set or change any data.
Cancel operation. Does not send or store anything and closes
the dialog box.
A greyed Cancel button indicates that it is not possible to quit
from this dialog box.
Replies Yes to a question asked of the user.
Replies No to a question asked of the user.
E Nokia Mobile Phones Ltd.
Service Software Instructions
Page 21
NSW-5