Advertisement
Available languages
Available languages
ROUTINE MAINTENANCE
I Cleaning of air nozzles (blower)
To expel any water which may be in the pipes of the blower, re-
fer to the paragraph "Draining the blower circuit".
I Cleaning of tap fixtures
To prevent lime stains on the tap fixtures, dry the various com-
ponents after use. If you need to clean them, you can remove im-
purities with a cloth dipped in soapy water, followed by rinsing
with clean water and drying.
I Cleaning the tub
Cleaning is quick and easy. You can use any neutral non-abra-
sive liquid detergent.
To avoid deposits of lime scale (caused by particularly hard wa-
ter), we recommend you install a water softener.
The bath must be completely cleaned frequently, taking great care
not to damage the shininess of the bath or the metal parts.
NEVER USE ABRASIVE CLOTHS, POWDER DETERGENTS,
ACETONE OR OTHER SOLVENTS.
SPECIAL MAINTENANCE
You can polish the entire surface from time to time using an ordi-
nary polish.
In the event of scratches or substantial damage, we suggest you
contact your nearest Jacuzzi
We recommend cleaning the blower filter periodically (dependent
on how often the tub is used). To complete this, we recommend you
contact your nearest authorised Jacuzzi
GENERAL WARNINGS
I Jacuzzi
®
whirlpool baths are suitable for domestic or similar use
and must not be installed outside.
I We recommend that you fill the bath with water previously
mixed to a maximum temperature of 60 °C (that is, not boiling
water first and then cold water), in order to minimise the for-
mation of scale (which is encouraged by high water temper-
atures) and maintain the gloss of the surfaces.
I Never start the hydromassage if the cover of the suction intake
is dismantled.
I Remember that it is dangerous to use or reach out for electrical
equipment (radio, hair drier, etc.) when you are in the bath.
®
service centre.
Service Centre.
®
I At the end of the hydromassage, it is recommended that you switch
off the general switch installed on the supply line to the tub.
Wait for the phase for expelling water from the pipes connected
to the blower to come to an end.
This phase starts about 30 minutes after draining the tub. See
the chapter on the blower.
If you do not want to wait, start the function manually after drain-
ing the tub, then turn off the main switch.
I When the tub is used as a normal bathtub, remember that af-
ter draining it you need to clean the pipes connected to the
blower (nozzles located on bottom of tub) by doing the fol-
lowing:
- turn on the main switch located on the power supply line of
the tub;
- press key: the blower will come on for 30 seconds and
the residual water in the pipes will be expelled.
- turn off the main switch.
Advertisement
