Periodic Pressure Relief Valve Check - Greenlee RK06AT Instruction Manual

Connector Selection
Tool Range: Copper — 4 AWG to 500 kcmil (except as noted
This tool is cUL and UL classified for use with the following connector brands:
CONNECTOR BARREL
ANDERSON BLACKBURN
TYPE TYPE
Short VHSS
Copper
Splices
Long VHS
Short VHCS
Copper
Lugs
Long VHCL
*Use the number of crimps listed in the last column instead of
the number provided with the connector.

Periodic Pressure Relief Valve Check

Test the crimping tool periodically to ensure that the
pressure relief valve activates at the proper pressure.
Testing the Crimping Tool
1. Center a test slug between the nibs.
2. Activate the pump to advance the nibs. Continue
crimping until the pressure relief valve activates.
3. After achieving pressure relief, release the hydraulic
pressure at the pump. The ram will automatically
return to the start position and the nibs will retract.
Greenlee Tools, Inc.
BURNDY
®
CSP YS-L
CU YS
YA-2LN/YA-L/YA-2L
CTL-2/CTL
YA/YA-L-TC/YA-L-2TC
CTL-L/LCN YA-2N
GO
NO GO
RK06AT Hydraulic Crimping Tool
)
∆
ILSCO PANDUIT
CT SCSS/SCS
CTL SCL/SCH
∆
CSW LCAS/LCA
CRA/CRB LCD
∆
CLN, CLW
CRA-L/CRB-L LCB/LCC
CRA-2L/CRB-2L
∆
4. Evaluate the test slug as follows:
• If the test slug does not fit into GO slot, the pres-
sure relief valve is set too high. Send the pump to
an authorized Greenlee service center.
• If the test slug fits into the GO slot, the pressure
relief valve is set correctly.
• If the test slug fits into the NO GO slot, the pres-
sure relief valve is set too low. Send the pump to
an authorized Greenlee service center.
7
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
PENN-
T&B
UNION
54506–54518 BCU
54806–54818 BBCU 4 to 4/0 AWG:
54106–54118
BLU
54206–54286
54906BE–54919BE
BBLU
54854BE–54876BE
ILSCO Capacity: 4 AWG to 250 kcmil
NO. OF
CRIMPS*
1 crimp
250 to
500 kcmil:
2 crimps