Connecting To Web-Based Interface - D-Link DAP-1620 User Manual

DAP-1620 AC1300 MU-MIMO Wi-Fi Range Extender
User Manual

Connecting to Web-based Interface

When you have configured your computer, you can access the web-based interface and configure
needed parameters (configure the wireless network, change the operating mode of the device,
configure MAC-address-based filtering, etc.).
Start a web browser (see the Before You Begin section, page 14). In the address bar of the web
browser, enter the IP address of the extender (by default, the following IP address is specified:
192.168.0.50). Press the Enter key.
Figure 22. Connecting to the web-based interface of the DAP-1620 device.
If the error " The page cannot be displayed " (or " Unable to display the page "/" Could not
!
connect to remote server ") occurs upon connecting to the web-based interface of the
extender , make sure that you have properly connected the extender to your computer.
If the device has not been configured previously or the default settings have been restored, after
access to the web-based interface the Initial Configuration Wizard opens (see the Initial
Configuration Wizard section, page 37).
Figure 23. The page for running the Initial Configuration Wizard.
Page 32 of 125
Installation and Connection