D-Link DAP-1620 User Manual page 87

DAP-1620 AC1300 MU-MIMO Wi-Fi Range Extender
User Manual
To activate the Super Mesh function, on the tab of the relevant band, move the Enable Super
Mesh switch to the right. You can specify the following parameters:
Parameter
Domain
IPv6
Enable gateway
Network name (SSID)
Figure 68. The Wi-Fi / Super Mesh page.
An identifier which shows that the device belongs to a certain Mesh
network. This value should be the same for all devices of your Mesh
network.
If you need to use IPv6 for configuring the Mesh network, move the
IPv6 switch to the right.
Move the switch to the right to allow devices of the Mesh network to
use this device for connecting to the Internet.
It is recommended to move the switch to the left when configuring a
subordinate device.
A name of the Mesh network. This value should be the same for all
devices of your Mesh network.
Clients connected to devices of a Mesh network cannot see the Mesh
network and cannot connect to it.
Page 87 of 125
Configuring via Web-based Interface
Description