Toshiba E-STUDIO2323AM Topaccess Manual page 45

5.[Administration] Tab Page
Item name
1 Enable SMTP Client
2 Enable SSL
Not all operating systems support SSL for all protocols.
3 SSL/TLS
When you select [SMTP over SSL], set the port number to "465".
4 SMTP Server Address
If you use FQDN to specify the SMTP server, you must configure the DNS server and enable the DNS in the DNS
Session.
5 POP Before SMTP
6 Authentication
7 Login Name
8 Password
9 Port Number
If the input value is less than 1, the value is changed to 1. If the input value is more than 65535, the value is
changed to 65535.
10 SMTP Client Connection
Timeout (1-180)
When this is enabled, this equipment sends an Email to the specified SMTP
server for transmission over the Internet. [Enable] is set as the default.
Select whether the SSL (Secure Sockets Layer) is enabled or disabled for
accessing an SMTP server.
 Disable — Select this to disable the SSL.
 Accept all certificates — Select this to enable the SSL to accept all
certificates at authentication.
Select the protocol for the SSL when the [Enable SSL] option is enabled.
 Over SSL — Select this to send a message in SSL (Secure Socket Layer).
 STARTTLS — Select this to send a message in TLS (Transport Layer Security)
using STARTTLS that is the extension command for SMTP transmission.
Enter the IP address or FQDN (Fully Qualified Domain Name) of the SMTP
server when [Enable SMTP Client] is enabled. You can enter up to 128
alphanumerical characters, symbols, and spaces.
Select whether the POP Before SMTP authentication is enabled or disabled.
[Disable] is set as the default.
Select the type of authentication to access the SMTP server.
 Disable — Select this to access the SMTP server using no authentication.
 Auto — Select this to access the SMTP server using the appropriate
authentication that this equipment detects.
Enter the log-in name to access the SMTP server if the SMTP authentication is
enabled. You can enter up to 64 alphanumerical characters, symbols, and
spaces.
Enter the password to access the SMTP server if the SMTP authentication is
enabled. You can enter up to 64 alphanumerical characters, symbols, and
spaces.
The password input is displayed in asterisk symbols.
Enter the port number for accessing the SMTP server when [Enable SMTP
Client] is enabled. The port number depends on the port setting in the SMTP
server. You can enter a value in the range from 1 to 65535. Generally the
default value "25" is used.
Specify the time limit for the connection of an SMTP server between 1 to 180
seconds. The default value is 30 seconds.
Description
[Setup] Item List 45