Toshiba E-STUDIO2323AM Topaccess Manual page 38

5.[Administration] Tab Page
Item name
Obtain a POP3 Server
6
Address Automatically
When the DHCP server does not have a POP3 server address, the data are left blank in the POP3 server address
even if you set the correct POP3 server address manually in the POP3 Network Service. In that case, select
[Disable] here and set the correct POP3 server address in the POP3 Network Service.
 P.46 "Setting up POP3 Network Service"
7 IP Address
Subnet Mask
8
9 Default Gateway
*1 This item is not available for e-STUDIO2323AM/2823AM.
38 [Setup] Item List
Select [Enable] when you want to obtain a POP3 server address automatically
*1 using the DHCP server. This setting will apply only when [No AutoIP] or
[Dynamic] is selected in the Address Mode option. [Disable] is set as the
default.
Enter the static IP address for your equipment when [Static IP] is selected in
the [Address Mode] box. Specify within the range from 0 0 0 0 to 255 255 255
255.
However, you cannot set 0.0.0.0 and 255.255.255.255.
Enter the subnet mask if required when [Static IP] is selected in the [Address
Mode] box. Specify within the range from 0 0 0 0 to 255 255 255 255.
However, you cannot set 0.0.0.0 and 255.255.255.255.
Enter the gateway address if required when [Static IP] is selected in the
[Address Mode] box. Specify within the range from 0 0 0 0 to 255 255 255 255.
However, you cannot set 0.0.0.0 and 255.255.255.255.
Description