Toshiba E-STUDIO2323AM Topaccess Manual page 37

5.[Administration] Tab Page
Item name
1 Ethernet Speed Duplex Mode Select the ethernet speed.
 When you select a specific ethernet speed, you must select the same one as set in the connected network. If
you do not know the ethernet speed that must be used, select [Auto].
 If the network is not stable, power OFF the equipment then ON.
Address Mode
2
Obtain a Domain Server
3
Address Automatically
When the DHCP server does not have a primary and secondary DNS server addresses, the data are left blank in
the primary and secondary DNS server addresses, even if you set the correct primary and secondary DNS
server addresses manually in the DNS Session. In that case, select [Disable] here and set the correct primary
and secondary DNS server address in the DNS Session.
 P.42 "Setting up DNS Session"
4 Obtain a WINS Server
Address Automatically
When the DHCP server does not have a primary and secondary WINS server addresses, the data are left blank
in the primary and secondary WINS server addresses, even if you set the correct primary and secondary WINS
server addresses manually in the SMB Session. In that case, select [Disable] here and set the correct primary
and secondary WINS server address in the SMB Session.
 P.43 "Setting up SMB Session"
5 Obtain an SMTP Server
Address Automatically
When the DHCP server does not have an SMTP server address, the data are left blank in the SMTP server
address even if you set the correct SMTP server address manually in the SMTP Client. In that case, select
[Disable] here and set the correct SMTP server address in the SMTP Client.
 P.44 "Setting up SMTP Client"
Select how to set the IP address.
 Static IP — Select this to assign the static IP address manually. When this is
selected, enter the static IP address in the [IP Address] box.
 Dynamic — Select this to assign the IP address using the DHCP with Auto-IP
addressing enabled. The IP address, subnet mask, and default gateway can
be automatically acquired from the DHCP server if the network supports
DHCP. However, if the network does not support DHCP, use the AutoIP
function to assign an IP address.
 No AutoIP — Select this to assign the IP address using the DHCP with Auto-
IP addressing disabled. The IP address, subnet mask, and default gateway
can be automatically acquired from the DHCP server if the network supports
DHCP. If the communication with the DHCP cannot be established, the
previous IP address is used.
Select [Enable] when you want to obtain a domain server address
automatically using the DHCP server. This setting will apply only when [No
AutoIP] or [Dynamic] is selected in the Address Mode option. [Enable] is set as
the default.
Select [Enable] when you want to obtain a primary or secondary WINS server
address automatically using the DHCP server. This setting will apply only
when [No AutoIP] or [Dynamic] is selected in the Address Mode option.
[Enable] is set as the default.
Select [Enable] when you want to obtain an SMTP server address
*1 automatically using the DHCP server. This setting will apply only when [No
AutoIP] or [Dynamic] is selected in the Address Mode option. [Disable] is set as
the default.
Description
[Setup] Item List 37