Before You Begin; Location Of Controls - Lopi Radiant Plus GSB2 Owner's Manual

32

Before You Begin


Read this entire manual before you use your new heater (especially the section "Safety Precautions"
on pages 4 & 5). Failure to follow the instructions may result in property damage, bodily injury, or
even death.
Turn off the main gas supply to the appliance during appliance installation or maintenance.
During appliance installation or maintenance or in case of remote control malfunction turn off the
main gas supply.

Location of Controls

To access the gas control valve, open the control door on the face. The controls are shown below.
Shutoff Valve
On/Off Switch
Continuous / Intermittent
Pilot Switch
Flame Adjust Knob
Battery Tray – or -
Optional Remote
Receiver
Optional Blower Knob
© Travis Industries
Operation
This valve shuts off gas to the insert.
This control is used to turn the heater on and off.
This switch controls how the pilot flame works: continuous; or, intermittent
(pilot turns on and off with the burner). See the section
"Continuous/Intermittent Pilot" for details.
This knob controls the flame height from low ("LO") to high ("HI"). The pointer
above the knob points to the position this knob is in.
The insert ships with a battery tray (backup power for power outages). If
using the optional remote, the remote receiver replaces the battery tray (it
also includes a switch that replaces the on/off switch).
This knob controls the speed of the internal convection blower that pushes
the heated air into the room.
4/23/2021 - 1449 Radiant Large GSB2