Before You Begin; Location Of Controls - Lopi ProBuilder 36 CF GSB2 Owner's Manual

6

Before You Begin


Read this entire manual before you use your new fireplace (especially the section "Safety
Precautions" on pages 4 & 5). Failure to follow the instructions may result in property damage, bodily
injury, or even death.

Location of Controls

There is a door on the lower portion of the screen assembly to provide access to the manual controls on
the fireplace. The door is held closed by two magnets. Open the door by gently pulling outward on the
upper portion of the lower trim.
screen removed)
Continuous / Intermittent Pilot Switch
On/Off Switch
Gas Control Knob
Flame Adjust Knob
Continuous Pilot --
GreenSmart Pilot
Optional Remote Receiver The receiver is used in conjunction with the optional remote thermostat. It is
Blower Dial
© Travis Industries
Operation
Shutoff Valve
(accessible with
Flame Adjust Knob
On/Off Switch
Battery Tray - or - Optional Remote Receiver
This control is used to turn the heater on and off.
This knob is used to control gas to the heater and for starting the pilot. There
are three positions, ON, OFF, & PILOT. The pointer to the left of the knob
indicates the position this knob is in.
This knob controls the flame height from low ("LO") to high ("HI"). The
pointer above the knob points to the position this knob is in.
This switch controls how the pilot flame works. See the section "Continuous
Pilot / GreenSmart Pilot" for details.
used to control the remote and replaces the on/off switch for direct operation.
This knob controls the speed of the internal convection blower that pushes
the heated air into the room.
Rotate the Control Door Down to
Blower Dial
2/11/19 - 1502
Access Controls
PB 36 CF Operation (Aust)