Auto Update - PURE Elan Connect User Manual

Auto-update
Auto-update works with data sent over DAB, FM or network. The clock is only updated when in a
corresponding mode, so it is best to select a mode you use regularly.
DAB and FM use time signals broadcast with radio transmissions.
Network uses a time signal sent from the Internet radio portal when in any network-connected mode.
1. Select Update from DAB, Update from FM, Update from Network or No update.
2. If you are updating from the network, set your time zone.
3. If your country uses daylight saving, the automatically updated time from the network may be wrong
by one hour. When daylight savings are in effect (during the winter), turn on the Daylight savings option
to rectify this.
Note that if you are updating the time from DAB or FM, the Daylight savings option has no effect on the
clock's time.
Elan Connect will auto-update from the selected Mode when time information is available
Network
Elan Connect is compatible with all common network protocols and encryption methods, including Wi-Fi
Protected Setup (WPS).
To connect Elan Connect to your network, you need a Wi-Fi wireless router, together with password
key if set.
SSID
Your Wi-Fi
Other Wi-Fi 1
Other Wi-Fi 2
Other Wi-Fi 3
Other Wi-Fi 4
Select 'Network wizard' , and then select a network from the list.
If the network is open (non-encrypted), Elan Connect connects and no further details are
required; see Completion below.
Password protected network
Key:
a
0 1 2 3 4 5 6
7 8 9 .
, a
f g h i
m n o p q r s
To enter the network's key (password), use the Select control to highlight the next relevant
character and press to select each character in turn.
Backspace, OK and Cancel are included to the right of the password screen. These can be
accessed just using the Select control. Pressing the Info key moves the selection highlight to the
Back Space option and back again.
BKSP
- _ @ OK
b c d e
CANCEL
j k l