Setup Wizard - PURE Elan Connect User Manual

Setting up
Elan Connect is easy to use. To play Internet Radio, DAB FM radio or Bluetooth, all you need is a USB power
source;
A. Place Elan Connect on a suitable surface.
B. Extend the telescopic antenna.
C. Connect the supplied USB cable between Elan Connect and a USB power adaptor.
*Not included

Setup wizard

When the Elan Connect is tuned on for the first time, it runs through a setup wizard to configure settings for
date/time and network. Once this has finished, the system is ready to use in most modes.
Note: To change these settings later, select Menu >System settings > and select the required settings
option(s). To run the setup wizard again, select Menu > System settings > Setup wizard.
The Network settings can be reset later by manually running the Network wizard, select Menu > System
settings > Network >Network wizard .
Select Yes to start the setup wizard. If you choose No, a second screen asks if you would like to run
the wizard next time the Elan Connect is started; select Yes or No. The system then starts without
configuring time/date and network settings and enters the Main Menu.
Note: If power is removed while the wizard is in progress, the wizard will run again next time the Elan
Connect is started.
12/24 hour display
To change between 12 and 24 hour display, select Time/Date > Set format 12/24 hour format and then select
your preference.
Time/date
The date and time are displayed as dd-mm-yyyy and hh:mm with the first value, dd, active (flashing).
Adjust each value with the Select control. As each value is set by pressing the Select control, the next value
becomes active ready for adjustment.
USB A
C
B
A