PURE Elan Connect User Manual page 10

Other settings
Dynamic range compression (DRC)
FM
To enter FM mode: Press Source, then scroll and select FM radio.
Selecting stations
The first time you select FM radio, Elan Connect is set to the lowest frequency in the FM band.
On subsequent selections the last used frequency/station is displayed.
To scan for a station in FM mode press and hold the skip forward or skip back button. Elan
Connect scans through the FM band frequencies, showing the current frequency on the screen
display.
Alternatively, you can short press the skip forward or skip back button to tune in 50 kHz steps.
FM
Buzz FM
Radio for the
nation
RDS
Now playing information
While FM radio is playing, the screen shows its frequency, or if RDS information is
available, station name and any further RadioText' information. If no information is
available, just the frequency and a No RadioText message is shown.
To view further information about the broadcast press Info. Each time you press Info, the
next set of information is displayed, cycling through:
Settings
Scan settings
Slideshow
The normal now playing screen shows a thumbnail of the currently
available slideshow image. (If no slideshow image is available a default
DAB thumbnail image is displayed). A long press of the 'Info' button cycles
through the following slideshow displays.
1) Slideshow image and DLS text being broadcast by the current station.
2) Full screen slideshow
3) Normal now playing screen.
To view further information Press Info .
Each time you press Info , the next set of information is displayed, cycling
through: DLS text, DL Plus information (this is only displayed if broadcast
by the station), programme type, ensemble name, channel number/
frequency, signal strength, Bit rate, power status and date.
This function reduces the difference between the loudest and quietest audio
being broadcast.Effectively, this makes quiet sounds comparatively louder, and
loud sounds quieter.
Select Menu > DRC > The options available are: DRC high | low | off.
10:27
RDS Radio text programme type
Frequency
Date
By default, FM scans stop only at stations with good signal strength .To change
the scan settings, to stop at all stations select Menu > Scan setting > All Stations' .
This may include poor quality audio from weak stations.