Table of Contents
Advertisement
<HDMI IN> terminal
<DVI-D IN> terminal
<DIGITAL LINK>
terminal
<SDI IN> terminal
<MULTI PROJECTOR
SYNC IN> terminal/<3D
SYNC 1 IN/OUT>
terminal (dual purpose)
<MULTI PROJECTOR
SYNC OUT>
terminal/<3D SYNC 2
OUT> terminal (dual
purpose)
Connecting
<SERIAL IN> terminal
terminal/slot
<SERIAL OUT> terminal D-Sub 9 p x 1, RS-232C compliant, for computer control
<REMOTE 1 IN>
terminal
<REMOTE 1 OUT>
terminal
<REMOTE 2 IN>
terminal
<LAN> terminal
<USB> terminal
<DC OUT 1> terminal
<DC OUT 2> terminal
<SLOT>
Acoustic noise
*2
Operating temperature
Operating
environment
Operating humidity
Operation position
*1 This terminal is compatible with the etherCON
*2 Measurement, measuring conditions, and method of notation all comply with ISO/IEC 21118:2020 international standards.
*3 The operating environment temperature should be between 0 °C (32 °F) and 40 °C (104 °F) if the projector is used at an altitude between 1 400 m
(4 593') and 4 200 m (13 780') above sea level.
*4 The operating environment temperature should be between 0 °C (32 °F) and 40 °C (104 °F) when the optional Wireless Module (Model No.:
AJ-WM50 Series) is attached.
*5 When the [PROJECTOR SETUP] menu → [OPERATION SETTING] → [OPERATING MODE] is set to [NORMAL] or [ECO], and the operating
environment temperature exceeds the following value, the light output may be reduced to protect the projector.
f When using the projector at an altitude lower than 2 700 m (8 858') above sea level: 35 °C (95 °F)
f When using the projector at an altitude between 2 700 m (8 858') and 4 200 m (13 780') above sea level: 25 °C (77 °F)
306 - ENGLISH
Chapter 7 Appendix — Specifications
HDMI x 1, HDCP 2.2 compatible, Deep Color compatible
DVI-D 24 p x 1, single link, DVI 1.0 compliant, HDCP compatible
RJ-45 x 1, for network and DIGITAL LINK connections (HDBaseT
(class 2) compatible, 100Base-TX, Art-Net compatible, HDCP 2.2 compatible, Deep Color
compatible
BNC x 1
BNC x 1, TTL high impedance
When [3D SYNC MODE] is set to output, TTL output: Maximum 10 mA
BNC x 1, TTL output: Maximum 10 mA
D-Sub 9 p x 1, RS-232C compliant, for computer control
M3 stereo mini jack x 1, for remote control (wired)/for projector connection control
M3 stereo mini jack x 1, for remote control (wired)/for projector connection control
D-Sub 9 p x 1, for contact control
RJ-45 x 1, for network connection, PJLink (class 2) compatible, 10Base-T/100Base-TX, Art-
*1
Net compatible
USB connector (type A) x 1, for connecting the optional Wireless Module (Model No.:
AJ-WM50 Series), for connecting USB memory
USB connector (type A) x 2, for power supply only (DC 5 V, 2 A total for two terminals)
SLOT x 1, SLOT NX specification, for installing the Interface Board
49 dB
49 dB
46 dB
0 °C (32 °F) to 45 °C (113 °F)
10 % to 80 % (no condensation)
[FLOOR/CEILING], [FRONT/REAR]
series cable connector (NE8MX*, NE8MC*) of Neutrik.
®
when [OPERATING MODE] is set to [NORMAL]
when [OPERATING MODE] is set to [ECO]
when [OPERATING MODE] is set to [QUIET]
*3*4*5
compliant), PJLink
TM
Advertisement
Table of Contents
