Table of Contents
Advertisement
Note
f The settings in [RESOLUTION] and [VERTICAL SCAN FREQUENCY] are displayed in [EDID STATUS].
f The resolution and vertical scanning frequency settings may also be required on your computer or video device.
f The computer, video device, or projector in use may require the power to be turned off and on again after configuring settings.
f A signal may not be output with the resolution and vertical scanning frequency that have been set, depending on your computer or video
device.
When the optional Interface Board for DVI-D 2 input (Model No.: ET-MDNDV10) is installed
Setting [SIGNAL LEVEL] in [SLOT IN] (DVI-D input)
1)
Press as to select [SLOT IN].
2)
Press the <ENTER> button.
f The [SLOT IN] screen is displayed.
3)
Press as to select [DVI-D1] or [DVI-D2], and press the <ENTER> button.
f The [DVI-D1] screen or the [DVI-D2] screen is displayed.
4)
Press as to select [SIGNAL LEVEL].
5)
Press qw to switch the item.
f The items will switch each time you press the button.
[AUTO]
[0-255:PC]
[16-235]
Note
f The optimal setting varies depending on the output setting of the connected external device. Refer to the operating instructions of the
external device regarding the output of the external device.
Setting [EDID SELECT] in [SLOT IN] (DVI-D input)
1)
Press as to select [SLOT IN].
2)
Press the <ENTER> button.
f The [SLOT IN] screen is displayed.
3)
Press as to select [DVI-D1] or [DVI-D2], and press the <ENTER> button.
f The [DVI-D1] screen or the [DVI-D2] screen is displayed.
4)
Press as to select [EDID SELECT].
5)
Press qw to switch the item.
f The items will switch each time you press the button.
[EDID3]
[EDID1]
[EDID2:PC]
Note
f The data for Plug and play will change when the setting is changed. Refer to "List of compatible signals" (x page 309) for a resolution that
supports plug and play.
Setting [EDID MODE] in [SLOT IN] (DVI-D input)
1)
Press as to select [SLOT IN].
Chapter 4 Settings — [DISPLAY OPTION] menu
Automatically sets the signal level.
Select this item when the signal output from the DVI-D terminal of the external device (such as a
computer) is input to the <DVI-D IN 1> terminal or the <DVI-D IN 2> terminal.
Select this item when the signal output from the HDMI terminal of the external device (such as a Blu-
ray disc player) is input to the <DVI-D IN 1> terminal or the <DVI-D IN 2> terminal using a conversion
cable, etc.
Determines the moving image or still image signal automatically.
Select this item mainly when an external device that will output the moving image signal (such as a
Blu-ray disc player) is connected to the <DVI-D IN 1> terminal or the <DVI-D IN 2> terminal.
Select this item mainly when an external device that will output the still image signal (such as a
computer) is connected to the <DVI-D IN 1> terminal or the <DVI-D IN 2> terminal.
ENGLISH - 149
Advertisement
Table of Contents
