Table of Contents
Advertisement
Note
f Even if [DEFAULT] is set to [OFF], the content of an error or a warning is automatically displayed when it occurs.
f This can also be set with operation in the information monitor. For details, refer to "Using the information monitor function" (x page 261).
Setting the information to display
Set the items to display on the information monitor during no operation.
1)
Press as to select [INFO MONITOR SETTING].
2)
Press the <ENTER> button.
f The [INFO MONITOR SETTING] screen is displayed.
3)
Press as to select [USER VIEW].
4)
Press the <ENTER> button.
f The [USER VIEW] screen is displayed.
5)
Press as to select an item.
[INPUT]
[SIGNAL NAME]
[AC VOLTAGE]
[INTAKE AIR TEMP.]
[EXHAUST AIR TEMP.]
[SHUTTER]
[OSD]
[IP ADDRESS(WIRED)]
*1 The representative input terminal is displayed when one image is displayed with multiple input signals.
6)
Press qw to switch the setting.
f The items will switch each time you press the button.
[ON]
[OFF]
f Repeat Steps 5) to 6) until the desired display items are set.
Note
f This can also be set with operation in the information monitor. For details, refer to "Using the information monitor function" (x page 261).
Setting the direction to display
Set the direction of the text to display in the information monitor.
1)
Press as to select [INFO MONITOR SETTING].
2)
Press the <ENTER> button.
f The [INFO MONITOR SETTING] screen is displayed.
3)
Press as to select [DIRECTION].
4)
Press qw to switch the item.
f The items will switch each time you press the button.
[AUTO]
[NORMAL]
[FLIPPED]
Note
f This can also be set with operation in the information monitor. For details, refer to "Using the information monitor function" (x page 261).
202 - ENGLISH
Chapter 4 Settings — [PROJECTOR SETUP] menu
Currently selected input terminal
Input signal name
Input supply voltage
Intake air temperature of the projector
Exhaust air temperature of the projector
Status of the shutter ([CLOSE]: Shutter function enabled; [OPEN]: Shutter function disabled)
Status of the on-screen display function ([ON]: Display; [OFF]: Hide)
IP address of the wired LAN
Displays the items in the information monitor.
Does not display the items in the information monitor.
Detects the orientation of the projector by the built-in angle sensor, and automatically sets the
direction of the text displayed in the information monitor. Set [AUTO] normally.
Select this item when installing the projector on a desk, etc.
Select this item when installing the projector with the top surface of the projector facing down such as
ceiling attachment.
Displays the text inverted upside down from when [NORMAL] is set.
*1
Advertisement
Table of Contents
