Panasonic DLP PT-RZ34K Operating Instructions Manual page 156

Table of Contents

Advertisement

Setting [BIT DEPTH] in [SLOT IN] (SDI input)
1)
Press as to select [SLOT IN].
2)
Press the <ENTER> button.
f The [SLOT IN] screen is displayed.
3)
Press as to select [SINGLE LINK SETTING] or [DUAL LINK SETTING], and press the <ENTER>
button.
f The [SINGLE LINK SETTING] screen or the [DUAL LINK SETTING] screen is displayed.
f Proceed to Step 5) when [DUAL LINK SETTING] is selected.
4)
Press as to select [SDI1], [SDI2], [SDI3], or [SDI4], and press the <ENTER> button.
f The [SINGLE LINK SETTING] screen for the selected item is displayed.
5)
Press as to select [BIT DEPTH].
6)
Press qw to switch the item.
f The items will switch each time you press the button.
[AUTO]
[12-bit]
[10-bit]
Setting [SIGNAL LEVEL] in [SLOT IN] (SDI input)
1)
Press as to select [SLOT IN].
2)
Press the <ENTER> button.
f The [SLOT IN] screen is displayed.
3)
Press as to select [SINGLE LINK SETTING] or [DUAL LINK SETTING], and press the <ENTER>
button.
f The [SINGLE LINK SETTING] screen or the [DUAL LINK SETTING] screen is displayed.
f Proceed to Step 5) when [DUAL LINK SETTING] is selected.
4)
Press as to select [SDI1], [SDI2], [SDI3], or [SDI4], and press the <ENTER> button.
f The [SINGLE LINK SETTING] screen for the selected item is displayed.
5)
Press as to select [SIGNAL LEVEL].
6)
Press qw to switch the item.
f The items will switch each time you press the button.
[64-940]
[4-1019]
When the optional Interface Board for 12G-SDI Optical (Model No.: ET-MDNFB10) is installed
Set this item according to the input and output signals when this Interface Board is installed in the slot.
Setting [SDI OPT 1/2 OUT] in [SLOT IN] (OPT input)
Set whether or not to output the signal from the <SDI OPT 1/2 OUT> terminal.
1)
Press as to select [SLOT IN].
2)
Press the <ENTER> button.
f The [SLOT IN] screen is displayed.
3)
Press as to select [SDI OPT 1/2 OUT].
4)
Press qw to switch the item.
f The items will switch each time you press the button.
156 - ENGLISH
Chapter 4 Settings — [DISPLAY OPTION] menu
Automatically selects [12-bit] or [10-bit].
Fixes to [12-bit].
Fixes to [10-bit].
Normally use this setting.
Select this item when gray is displayed as black.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dlp pt-rz34kdDlp pt-rz34ke

Table of Contents