Safety sensor for automatic sliding doors (9 pages)
Summary of Contents for BEA Smart Focus
Page 1
IEC 61000-6-2; IEC 61000-6-3; ISO 13849-1 Performance Level «c» CAT. 2 (under the condition that the door control system monitors the sensor at least once per door cycle) Specifications are subject to change without prior notice. All values measured in specific conditions. 75.5390.02 SMART FOCUS 20191002 Page 1 of 4...
Page 2
If the LED continues to flash, the sensor The sensor can also be installed on the surface by using the must be adjusted (see next page). surface mount accessory (sold separately). Page 2 of 4 75.5390.02 SMART FOCUS 20191002...
Page 3
Use F2 in any of the following conditions: • monitoring input = active high • monitoring input = active low • no monitoring required When finished, confirm DIP changes with a long push of the push button. 75.5390.02 SMART FOCUS 20191002 Page 3 of 4...
Page 4
BEA, Inc. does not guarantee any use of the sensor outside of its intended purpose. BEA, Inc. strongly recommends that installation and service technicians be AAADM-certifi ed for pedestrian doors, IDA-certifi ed for doors/gates, and factory-trained for the type of door/gate system.