Driving Behaviour; General Settings - Sunrise Medical PowerTalk2 User Manual

9�2 Driving Behaviour
Parameter
Info
Mode
Custom support level 1
Motor power
Sensitivity assist rim
Max. Speed Forward
Custom support level 2
Motor power
Sensitivity assist rim
Max. speed forward
Custom support level 2
Motor power
Sensitivity assist rim
Max. speed forward
9�3 General Settings
Parameter

General settings

Automatic switch off
Beeps ON/OFF
Wheel Left/Right
Speed limit
WheelDrive Parameter List - E1801_20181018
L Meaning
In this field the driving mode can be set by entering "1" for Gentle
driving, "2" for Normal driving, "3" for Sport. These are the 3 predefined
1
setting. When customization is required Custom setting "4" must be set.
Only when setting "4" is set, the custom support levels below apply.
The settings in this pulldown belong to User Interface button 1
The motor power value can be set from 1 to 6. A higher value means a
2
higher torque and faster acceleration.
2
The sensitivity value determines how much displacement of the assist
rim you need to get support. With a high value, the movement starts
with a little displacement of the assist rim; with a low value it starts later,
after more displacement.
This value determines the maximum speed you can reach with the
2 Drive rim on flat surfaces. The maximum is 6 km/u, corresponding with
value "6".
The settings in this pulldown belong to User Interface button 2
2 See "Custom support level 1"
2 See "Custom support level 1"
2 See "Custom support level 1"
The settings in this pulldown belong to User Interface button 3
2 See "Custom support level 1"
2 See "Custom support level 1"
2 See "Custom support level 1"
L Meaning
This value in minutes determines after how much time the wheel
1
switches off after not being used.
When selecting OFF (0), the system will not give any beeps. Also
1
warning beeps are disabled.
This value is set during factory setup and determines the type of wheel
3
(left or right)
The WheelDrive can speed up to the value set. Range is 1-15 km/h,
2 default is 15 km/h. When the slope is too steep, the speed cannot be
controlled to this value and the WD will speed up.
Rev.A 27