Table of Contents
Advertisement
5�5�3 General Settings
4 general settings can be personalized:
Automatic switch off time:
Beeps ON/OFF:
Wheel Left/Right: [L3]
Speed Limit:
Steps to set general settings:
1.
Fill in the desired values for
• Automatic switch off time
• Beeps ON/OFF
• Speed Limit
2.
Write the settings to the wheel by pressing button Write on the bottom.
3.
Do the same for the second wheel. (see paragraph "save and load settings" for an exact copy of the
settings to the second wheel).
PowerTalk2 User Manual - E1801_20181018
Determines after how many minutes the wheel switches off when not used.
When selecting OFF, the wheel will not give any beeps. This
also counts for warning beeps.
With this setting it is possible to re-configure the type of wheel. Normally this
setting is only used in case a Left wheel is rebuilt into a Right wheel or vice versa.
Warning: Make sure to configure the correct type of wheel.
The WheelDrive can speed up to the value filled-in.
Rev.A
17
Advertisement
Table of Contents
