Features Of The Rt-Br; Restrictions - Sekonic RT-BR Operating Manual

■

Features of the RT-BR

To use the radio triggering mode of the L-858D after the transmitter is installed, the flash
unit must be equipped with a radio function supported by a specified manufacturer, or a
receiver supporting the radio function must be connected to the flash unit.
Using the radio triggering mode, firing a flash or adjusting the output power by yourself
can be easily accomplished remotely.
Take measurements by placing the product at the subject's position with the light
●
receptor (retracted lumisphere) facing toward the light sources of main light and fill light
directly. Adjust the measured values for the desired lighting ratio.
Turn on all light sources to measure the final exposure, and point the lumisphere
●
(extended lumisphere) at the camera from the position of subject. (P14, P27)
Lamp 1
Subject
Figure 1
Note that this transmitter of RT-BR only supports the broncolor radio system.
Manufacturer
broncolor Radio Studio Address : 1 to 99
Lamp Address : 1 to 40, ALL
■

Restrictions

There are some cautions and restrictions regarding the use of this product.
Please read and understand the following before using the product.
Lamp 2
Lamp 1
Radio Studio/Lamp
Lamp 2
Subject
Figure 2
Flash light triggering and output power
control, modeling lamp ON/OFF
iv
broncolor：Lamp：1 to 40
Light meter (with the
transmitter installed)
Light source (with a
receiver built-in/installed)
Camera
Function