Table of Contents
Advertisement
2.
About broncolor Radio System
2-1
Overview
Triggering and controlling broncolor Wireless Flash require using broncolor Wireless
Flash units receiver attached or installed. Once the transmitter module is installed in your
L-858D, you will be able to adjust the power level and trigger flashes to get the look you
desire.
The broncolor radio system allows you to adjust the power level of each flash unit
individually when multiple flash units are in use. Also all flash units in the same Studio
Address can be triggered simultaneously, as well as the modeling lamp ON/OFF.
For more information about the meter, refer to the L-858D Operating Manual.
For more information about broncolor Wireless radio systems, go to https://www.
broncolor.swiss
NOTICE
Successful radio triggering depends on several factors. Please read these setup steps
before using the L-858D to radio trigger flash units.
1. It is the best to position the meter in sight of the radio receiver (or flash head).
2. Position the radio receiver so that it is away from large metallic objects, concrete, or
containers of water (like people).
3. Sometimes, conditions do not allow radio reception. These could include strong
local radio interference or being near objects that block or absorb the signal.
Repositioning the radio, even slightly, can reestablish contact. Alternatively, check to
see if the radio receiver is behind objects that absorb or block radio waves, such as
concrete, metal or low hill.
4. The working distance of the radio triggering system can vary with the orientation
and location of the meter and receivers, or the frequency (Radio Studio Address).
The maximum radio triggering range is approximately 30 meters. If the distance is
short, changing the Radio Studio Address (frequency) may improve the distance.
2. About broncolor Radio System
3
●
Advertisement
Table of Contents
