Table of Contents
Advertisement
8.
Troubleshooting
If your meter is not operating properly, as you expect, please consult the following
conditions and attempt the suggested solutions before contacting Sekonic. Non-operation
can be due to incorrect, mis-setting of the meter or battery condition. Should your meter
be malfunctioning, please contact place where meter was purchased or Sekonic for
service and repair.
Condition
Flash cannot be
triggered in Radio
Triggering Flash
Mode.
"Radio transmitter
installed cannot be
used in this meter." is
displayed.
Possible reasons
Is the radio receiver in the
flash compatible with the
meter's transmitter? Isn't any
other non-compatible brand or
manufacturer used?
Are the meter transmitter and
receiver set for the same Studio
Address?
Is the meter updated to the
latest firmware?
39
8. Troubleshooting
What to do
Make sure that the transmitter
installed to the meter and the
receiver currently used are using the
same radio system.
● broncolor website
URL: https://www.broncolor.swiss
Set the same Studio Address on the
transmitter and receiver.
Update the meter to the latest
firmware by connecting with
Data Transfer Software which is
downloadable from our website
below.
URL: https://www.sekonic.
com/support/downloads/
dtssoftwareformacandwindows.aspx
●
Advertisement
Table of Contents
