How To Install The Drain Hose (Only Pump Model); How To Clean Drain Filter (Only Pump Model) - Daewoo DWF-1095 E Series Manual

HOW TO INSTALL THE DRAIN HOSE (ONLY Px MODEL)
INSTALLATION OF THE DRAIN HOSE
Never forget to install drain hose before operating this washing machine.
There are a drain hose, a hose clamp, a hose fixture and a hose guide in the washing machine.
1 2
Connect the drain hose to Insert the hose fixture into
the drain outlet at the back hook hole at the side of the
side of the washing body, and fix the drain
machine, and fasten it hose by inserting it into the
tightly with the clamp hose fixture.
supplied.
Hook Hole
Drain
hose
Drain outlet
Hose Clamp
4
Hook the drain hose to the Or, connect the drain hose to a
edge of the tub, paying standpipe of a diameter greater
attention that there are no than that of the drain hose and at a
bends or constractions height of min. 70cm.
along the drain hose.
NOTES
1. Keep the drain hose fixed tightly in the hose fixture, or let the highst point of the drain hose be more
than 1m above the floor.
If not so, the water in the washing machine could be drained during operation.
2. Be sure that the height of the drain hose must be less than 1.5m above the floor.
If not so, the water in the washing machine could not drain.
3. The hose guide MUST be fitted to the drain hose. The drain hose sould not extend more than 55mm
from the end of the hose guide. This is to prevent 'SYPHONING'.
If necessary the drain hose can be trimmed to length.
19
3
Attach the hose guide,
included in the accwssory
kit, to guide the drain hose
over the tub or standpipe.
Pull Hose
through
Flex Hose
Hose Fixture
Guide
Drain Hose apart
5
Position the washing
machine next to the wall.
HOW TO CLEAN DRAIN FILTER (ONLY Px MODEL)
In this washer, the drain filter is equipped at the back side of it.
This drain filter is to screen the foreign stuffs such as threads, coins, pins, buttons etc...
And this should be cleaned frequently(every 5 times of use) for its smooth operation.
Drain problem could be caused if the drain filter is not cleaned at proper time.
Please Keep it clean.
Incase you clean the drain filter, please follow the instructions as below.
1 Remove the remained
1
water
• Put down the remained water in the
hose. And put a container under the
filter to collect water.
FITER
4 Remove the foreign
4
stuffs.
MUST be
ventilated
•
Clean the drain filter removing the
foreign stuffs.
NOTES
During the operation, the "OE" signal means drain error can displayed on the control panel.
In this case, the main cause of that problem is the blocking of the drain filter.
If you clean the drain filter following above instructions, you could continue the normal operation of this
washing machine to rest the program please turn the power off and on again.
2 Unscrew the cap. 2
• Turn the cap counter clockwise.
CAP
CONTAINER
5 Put the filter assembly
5
back.
• Put the filter along the guiding
prominence of the case. Please note
the left position of the filter adjusting
the groove to the guide rib.
FILTER
FILTER
CASE
GUIDE RIB
SLIT
CAP
CAP
3 Release the filter
3
assembly.
• Pull out the filter assembly off the case
of the main body.
FILTER
CAP
CASE
6 Lock the cap. 6
• Turn the cap clockwise tightly.
CAP
20