Daewoo DWF-1095 E Series Manual page 10

HOW TO USE THE DRAIN HOSE(ONLY xE MODEL)
INSTALLING DRAIN HOSE
Widen the drain clip and insert the drain
hose into the drain tap together with drain
hose. Dipping the end of the drain hose in
warm water makes easy to insert the drain
hose.
• In case that it goes over a doorsil • In case that it is connected when
water flow will be restricted if any the drain hose is extended, it
portion of the drain hose is may not exceed 3 meters.
raised more than 20 cm from the
ground.
20cm
HOW TO USE IN WINTER
•
To avoid the washing machine's being frozen.
- Remove the inside water of the washing machine completely.
- Remove the inside water of the inlet-hose and drain hose completely.
•
In case of being frozen.
- Dip the detached inlet-hose in the hot water (about 50°C) (* Don't use
above 50°C surely)
- Leave the tub alone for 10 minutes with poruing the hot water. (about
50 °C)
- Check the drain and inlet's operation after attaching the inlet-hose.
17
1 2
Insert the drain hose Secure the hose clip
into the drain tap. around the end of the
drain hose.
• Take care the end of the drain
hose. Do not sink the end of the
drain hose.
HOW TO REROUTE THE DRAIN HOSE (ONLY xE MODEL)
1 2
Loosen the back cover Detach the outside drain
screws on the rear side of hose with widening hose
the washer, and detach the clamp.
back cover.
4 5
Detach the inside drain Detach the drain hole
O ±
hose fixing screw with cover of the hoping
driver. direction.
7 8
Insert the inside drain Insert the outside drain
hose, and the fasten the hose together with the
fixing screw tightly. hose-fixing clamp.
3
Detach the fixing band by
hand.
6
Move the drain hose to the
direction to be changed,
and attach the fixing band.
9
Attach the detached back
cover again, and insert the
detached drain-hole-cover
instead of the original one.
18