Water Inlet Connection; Drain Hose Connection - Daewoo DWD-MH1011 Owner's Manual

Hide thumbs

Table of Contents

A concrete floor is the most suitable installation surface

for a washing machine, being far less prone to vibration

during the spin cycle than wooden floorboards or a carpeted

surface.

The machine must be level and securely positioned. The

distance between the machine and wall must be more than

10 cm.

To avoid vibrations during spinning, the machine should not

be installed on soft floor coverings.

The machine must stand perfectly level on all

four feet to ensure safe and proper operation.

Incorrect installation may increase electricity

and water consumption and may cause the

machine to move about.

To do these when the machine is not level:

Using the spanner turn locknut in a clockwise

direction. Then turn locknuts together with adjust

feet to unscrew.

Use a spirit level to check the machine is standing level.

Hold adjust feet securely with a pipe wrench. Turn locknut again

using the spanner until it sits firmly up against the housing.

Vibration and noise may occur if the locknuts do

not sit firmly up against the houses.

Drain hose connection

1. Direct into a sink

If the outlet spigot has not been used before, remove any blanking plug

that may be in place.

Push the drain hose onto the spigot and secure with a clip if required,

ensure a loop is formed in the drain hose to prevent waste from the sink

entering the washing machine.

If required, the drain hose can be extended to a length of 4 m.

Loop

2. Connected securely to a standpipe.

Firstly form a hook in the end of the drain hose using the "U" piece"

supplied.

Place the drain hose into your standpipe, which should have an internal diameter of approximately

38mm thus ensuring there is an air break between the drain hose and standpipe.

When discharging into a standpipe ensure that the top of the standpipe is no more than 90cm and

no less than 60cm above floor level.

"U" piece

supplied