Service Mode - Beko DRYPOINT M eco control DEC 1-30S Original Installation And Operation Manual

EN

6.3.3. Service mode

This function can be utilised to acquire an inspection for the permeation rate on the membrane dryer during preventive
service without having to dismantle the device. This inspection can determine whether this should be exchanged when
necessary.
The control system must already be located in setup mode to utilise the service mode (Refer to 6.3). If the service mode is
activated, then the solenoid valve will be closed permanently whereby only the measuring gas flow will flow through the
control system.
This function can be manually deactivated again, otherwise the control system will automatically reset this function to
normal mode after 30 seconds.
...
Power
∆
10 20 30
Test
+10 +5 0 °C
P
ressure
D
ew
P
oint
...
∆
35 45 55
Value
-5 -15 -26 °C
...
Power
∆
10 20 30
Test
+10 +5 0 °C
P
ressure
D
ew
P
oint
...
∆
35 45 55
Value
-5 -15 -26 °C
DRYPOINT M eco control
®
Preparation: Activate setup mode
→ "6.3. Carrying out settings (set-up mode)" on Page 28
• Press >>Test<< and >>Value<< button for 3 seconds
Activating:
• Press and hold the >>Test<< button for 10 seconds
→ Activation is displayed (all green LEDs flash quickly)
• Release the >>Test<< button: Valve closes, only measuring gas flow flows
All green LEDs flash in a 2 second cycle during the service mode.
Preparation: Device is in service mode
(All green LEDs flash every 2 seconds.)
Deactivating:
• Press and hold the >>Test<< button for 10 seconds
→ Activation is displayed (all green LEDs flash quickly)
• Release the button:
Device goes back into setup mode: Changes can now be made to the settings.
If no button is actuated for longer than 10 seconds then the device returns to normal mode
again.
Installation and operating manual
29