Replace Fuses In Harness (25R652); Recycling And Disposal; End Of Product Life - Graco Therm-O-Flow 200 Instructions - Parts Manual

Repair
Replace Fuses in Harness
(25R652)
The harness comes with fuses installed. Follow these
steps to replace a fuse.
1. Turn the Disconnect Switch (T) OFF.
2. Remove the Heat Control Box door (452).
3. Unscrew the spring-loaded fuse holder to open it.
The fuse can be easily removed by hand.
Open Here
F . 54
IG
4. Install the new fuse.
5. Reconnect and tighten the fuse holder.
6. Install the Heat Control Box Door (452).
To prevent damage to the AMZ circuit board, use
only 5 x 20 mm, 10 Amp AC, fast acting fuses. Fast
acting fuses are required for short-circuit protection.
116
NOTICE

Recycling and Disposal

End of Product Life

At the end of the product's useful life, dismantle and
recycle it in a responsible manner.
• Perform the Pressure Relief Procedure.
• Drain and dispose of fluids according to applicable
regulations. Refer to the material manufacturer's
Safety Data Sheet.
• Remove motors, batteries, circuit boards, LCDs
(liquid crystal displays), and other electronic
components. Recycle according to applicable
regulations.
• Do not dispose of batteries or electronic
components with household or commercial waste.
• Deliver remaining product to a recycling facility.
3A8005A